Xmart BYPASS 6K-10K Bedienungsanleitung PDF herunterladen

Switch Module

Quick Guide

Maintenance Bypass

Product Overview

Rack Mount the Unit

The module can be mounted to a 19” enclosure. Please follow below chart

for rack mount installation.

V. 1.0

Input/Output terminal

(refer to Diagram 2 for the details) UPS output terminal

UPS input breaker UPS input terminal

Maintenance bypass switch Utility input terminal

Control output signal slot

Output terminal

Introduction

The module is used as an external maintenance bypass switch to provide continuous

power without shutting down the connected loads during UPS scheduled maintenance

or battery replacement. It’s perfect to use in conjunction with 6K/10K VA UPS.

Installation

Unpacking and Inspection

Initial Setup

Unpack the package and check the package contents. The shipping

package contains:

Maintenance bypass switch module x 1

Quick guide x 1

Control signal cable x 1

NOTE: Before installation, please inspect the unit. Be sure that nothing inside the

package is damaged during transportation. Do not turn on the unit and notify the

carrier and dealer immediately if there is any damage or lacking of some parts.

Please keep the original package in a safe place for future use.

The Installation and wiring must be performed in accordance with the local electric

laws/regulations and execute the following instructions by professional personnel.

1) Make sure the mains wire and breakers in the building are enough for the rated

capacity of UPS to avoid the hazards of electric shock or fire.

NOTE: Do not use the wall receptacle as the input power source for the UPS, as its

rated current is less than the UPS's maximum input current. Otherwise, the receptacle

may be burned and destroyed.

2)Switch off the mains switch in the building before installation.

3)Turn off and shut down the connected UPS.

Diagram 1: Rear Panel View

Diagram 2: Terminal Overview

1 2

Inhaltsverzeichnis

Seite 1 - Maintenance Bypass

Switch ModuleQuick GuideMaintenance Bypass 2Product OverviewRack Mount the UnitThe module can be mounted to a 19” enclosure. Please follow below chart

Seite 2 - Operation

Specifications of Critical Components5Operation4Transfer to Maintenance Bypass To transfer to maintenance bypass from UPS, follow the below steps:Step

Kommentare zu diesen Handbüchern

Keine Kommentare

Xmart BYPASS 6K-10K Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Stromversorger Xmart BYPASS 6K-10K herunter. XMART BYPASS 6K-10K User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromversorger Xmart BYPASS 6K-10K